The Ardunio training Kit shall be complete set with different separate Board & kit for:-

• 5 x UNO
• 5 x ATMega

Specifications:

• Microcontroller : Uno R3, ATmega328P
• Operating Voltage : 5V Input Voltage (Recommended) : 7-12 V
• Inout Voltage (Limit) : 6-20 V
• Digital I/O Pins : 14 (of which 6 provide PWM output)
• PWM Digital I/O Pins : 6
• Analog Input Pins : 6
• DC Current per I/O Pin : 20
• DC Current for 3.3V Pin : 50 mA
• Flash Memory : 32 KB (ATmega328P) of which 0.5 KB used by bootloader
• SRAM : 2 KB (ATmega328P)
• EEPROM :1 KB (ATmega328P)
• Clock Speed :16 MHz
• LED Built In :13
• Length : 68.6 mm
• Width : 58.4 mm
• Weight : 25 g

Components Included in the Kit:

• 1 x Arduino UNO Rev3 & ATmega328P Board
• 1 x USB Cable
• 1 x 400-point Breadboard (Breadboard).
• 1 x Easy-to-assemble wooden base.
• 1 x 9 Volt Battery Snap
• 70 x Solid Core Flying Cables.
• Jumper Cables
• 6 x Photoresistors (VT90N2 LDR).
• 3 x 10K potentiometers. 10 x Pushbuttons.
• 1 x Temperature Sensor (TMP36).
• 1 x Tilt Sensor.
• 1 x LCD display (16x2 characters).
• 1 x LED (Bright White). 1 x LED (RGB).
• 8 x LED (Red).
• 8 x LED (Green).
• 8 x LED (Yellow). 3 x LED (Blue).
• 1 x 6 and 9 Volt DC Motor
• 1 x Servo motor.
• Piezo capsule
• 1 x Hx4N35 Optocouplers
• 5 x BC547 transistors
• 2 x IRF520 Mosfet Transistors.
• 5 x 100nF Capacitor
• 3 x 100uF Capacitors
• 5 x 100pF Capacitors
• 7 x lN4007 Diodes.
• 3 x Clear gel pieces (red, green, blue).
• 1 x Male Pin Strips (40x1). 22 x 220 ohm resistors.
• 7 x 560 ohm resistors. 7 x lK resistors.
• 7 x 4.7K resistors. 22 x 10K resistors. 7 x lM resistors.
• 7 x 10M resistors.