CRT

• Type: Large 6 screen with internal graticule. Approximate 12kV [2 KV] acceleration potential.
• Phosphor P31 standard
• Graticule 8 x10 div(div=10mm) Internal graticule
• Focusing: Possible (with automatic focus correction circuit)
• Trace rotation: Present
• Brightness adjustment: Possible

Z-AXIS INPUT (INTENSITY MODULTION)

• DC-coupled, positive-going signal decreases intensity: 5Vp-p signal cause
• noticeable modulation at normal intensity: DC to 2MHz
• Input impedance: 33kohm (typ.)[ 47k ohms(typ.)]
• Maximum input voltage:30V (DC + peak AC)

VERTICAL DEFLECTION SYSTEM (2 identical channels)

• Bandwidth and rise time
• DC to at least 50MHz (20 MHz) and rise time 7ns [17.5 ns] or less. DC to at least 7 MHz and rise time 50ns or less at magnifier extends. The AC coupled lower-3dB point is 10 Hz or less.
• Deflection factor :5mV/div to 5V/div in 10 calibrated steps in a 1-2-5 sequence. Uncalibrated continuous control extends deflection factor to at least 12.5Volts per division in the 5 Volts/div position, x5 magnifier increases sensitivity of each deflection factor setting to 1mV/div
• Accuracy:±3%
• Additional error for magnifier:±2%
• Display modes:CH1, CH2 (normal or invert), Alternate, Chopped (approximate 250 kHz), Added
• Input impedance:Approximately 1 M2 in parallel with 25pF
• Maximum input voltage:300V (DC+ peak AC) or 500 Vp-p AC at 1 kHz or less
• Input coupling:AC, GND, DC

HORIZONTAL DEELECTION SYSTEM

• Time base:0.2usidiv to 0.2s/div in 19 calibrated steps in a 1-2-5 sequence. Uncalibrated continuous control extends deflection factor to at least 0.5 seconds per division in the 0.2 sec/div position. x10mag extends maximum sweep rate to 20 ns/div [100ns/div),
• Accuracy:±3%
• Additional error for magnifier:+2%