The Industrial Electronics Circuits Trainer should consist of following nine modules with Function Generator and DC Power Supply:

Module-1: UJT and PUT Circuits

1. Experiment 1: UJT Volt-ampere Characteristic Curve Measurement
2. Experiment 2: UJT Relaxation Oscillator
3. Experiment 3: UJT Equivalent Circuit
4. Experiment 4: PUT Volt-ampere Characteristic Curve Measurement
5. Experiment 5: PUT Relaxation Oscillator

Module-2: SCR and GTO Circuits

1. Experiment 1: SCR Characteristic Measurement
2. Experiment 2: SCR Phase Angle Controlled Circuit
3. Experiment 3: Zener and SCR Circuit
4. Experiment 4: GTO Characteristic Circuit
5. Experiment 5: GTO Oscillation Circuit

Module-3: DIAC and TRIAC Circuits

1. Experiment 1: Zener Breakdown Characteristic Measurement
2. Experiment 2: DIAC Characteristic Measurement
3. Experiment 3: DIAC and TRIAC Circuit
4. Experiment 4: Zener and TRIAC Circuit
5. Experiment 5: PUT and TRIAC Circuit

Module-4: SCS and SSR Circuits

1. Experiment 1: SCS Characteristic Measurement
2. Experiment 2: SCS Equivalent Circuit
3. Experiment 3: SCS and SCR Circuit
4. Experiment 4: SSR DC Output Circuit
5. Experiment 5: SSR AC Output Circuit

Module-5: SBS Circuits and Temperature Sensors

1. Experiment 1: SBS Characteristic Measurement
2. Experiment 2: SBS and TRIAC Circuit
3. Experiment 3: Temperature Sensor Using SCR and LM335
4. Experiment 4: Temperature Sensor Using SCR and TC620

Module-6: Optical Elements and Application Circuits

1. Experiment 1: Photoresistor Circuit
2. Experiment 2: Photo Interrupter/Photo Coupler Circuit
3. Experiment 3: Photodiode Circuit
4. Experiment 4: Phototransistor Circuit

Module-7: MOSFET and Application Circuits

1. Experiment 1: MOSFET Characteristic Measurement
2. Experiment 2: MOSFET Regulator
3. Experiment 3: MOSFET Full Bridge Circuit
4. Experiment 4: MOSFET PWM Controlled Circuit
5. Experiment 5: MOSFET and PUT Circuit

Module-8: BJT and IGBT Application Circuits

1. Experiment 1: BJT Characteristic Measurement
2. Experiment 2: BJT Full Bridge Circuit
3. Experiment 3: BJT PWM Controlled Circuit
4. Experiment 4: IGBT Characteristic Measurement
5. Experiment 5: IGBT PWM Controlled Circuit

Module-9: SCR/SCS/DIAC/TRIAC Application Circuits

1. Experiment 1: SCR Application Circuit
2. Experiment 2: CdS and SCR Application Circuit
3. Experiment 3: DIAC and TRIAC Application Circuit
4. Experiment 4: SCS and SCR Application Circuit

• Function Generator & DC Power Supply Module:
• Waveforms: Sine, Triangle, Square, TTL Pulse
• Amplitude: >10 Vpp
• Impedance: 50Ω ±10%
• Duty Control: 30% ~ 60%
• Display: 6-Digit LED Display
• Frequency Range: 10Hz to 100 kHz (4 Ranges), 100Hz to 1 MHz (4 Ranges)
• Frequency Control: Separative Coarse and Fine Tuning
• Constant Voltage Output: ±5V, ±12V
• Variable Voltage Output: 0V ~ ±15V
• Power source: 220V AC ±10%, 50Hz