Logic Trainer

Order Code: 22235916.6

Category: General Lab Equipment I

The board consists of the following built-in parts: 5V D.C. at 200mA, IC Regulated Power Supply Internally connected. 10V D.C. at 100mA, IC Regulated Power Supply internally connected. 1 KHz Square Wave Generator. Switches to set Data &...



SPECIFICATION

  • The board consists of the following built-in parts:
  • 5V D.C. at 200mA, IC Regulated Power Supply Internally connected.
  • 10V D.C. at 100mA, IC Regulated Power Supply internally connected.
  • 1 KHz Square Wave Generator.
  • Switches to set Data & Address.
  • LEDs for visual indication of Address used Data conditions.
  • Four, J-K master slave flip-flops with preset and clear arrangement.
  • Five, 2-input NAND gates.
  • Four, 4-input NAND gates.
  • Pulser switch for clear arrangement.
  • LEDs for visual indication of output status of each flip-flop.
  • Single I/O port IC 8212.
  • Tristate buffer IC 74244.
  • Transistor BC 177.
  • SPDT switches for logic selection.
  • Adequate no. of other Electronic Components.
  • Mains ON/OFF switch, Fuse and Jewel light.
  • The unit is operative on 230V ±10% at 50Hz AC. Mains.
  • Adequate no. of patch cords stackable from rear both ends 2mm spring loaded plug length ½ metre.
  • Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections / observation of waveforms.
  • Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

Enquiry Form