Experimental Training Board has been designed specifically to study the behavior of the Reactive Elements and Time Dependent Network Analysis.
Practical experience on this board carries great educative value for Science and Engineering Students.

Object:

01. To study Charging & Discharging of a Condenser.
02. To Calibrate D.C. meter for A.C. voltage measurements.
03. To construct the vector (phasor) diagram for series L-R circuit and to calculate the power factor and "Q" at 50 Hz.
04. To study series LCR resonance circuit and its "Q".
05. To study series L-C resonance circuit and from it to find out the true value of "L".
06. To study series C-R circuit.
07. To study different types of filters.
08. To study the parallel R-C resonance circuit.
09. To study the parallel L-C resonance circuit and to find its "Q".
10. To verify circuit laws.
11. To find out the impedance and reactance of LCR reactive elements and to plot their reactance curves.
12. To plot "LISSAGOUS" figures.

Features:
 

The board consists of the following built-in parts:
01. Mains Transformer having secondary tappings of 10V, 20V, 30V, 40V, 50VA.C. at 500mA.
02. D.C. Voltmeter, 65mm rectangular dial with switch selectable ranges of 10V, 20V, 30V, 40V and 50V.
03. Four Rectifier diodes.
04. SPDT switch.
05. Potentiometer and adequate no. of other electronic components.
06. Mains ON/OFF switch, Fuse and Jewel light.

•  The unit is operative on 230V ±10% at 50Hz A.C. Mains.
•  Adequate no. of patch cords stackable from rear both ends 4mm spring loaded plug length ½ metre.
•  Good quality, reliable terminal/sockets are provided at appropriate places on panel for connections & observation of waveforms.
•  Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

Other Apparatus Required:

•  Decade Audio Frequency Generator
•  Digital Stop Clock
•  Cathode Ray Oscilloscope 20MHz