The unit shall perform the following experiments and investigations:
 Learning Objectives / Experiments

•  Physical principles of pneumatics and electro- pneumatics 
•  Fundamentals of, and terms used in, process control
•  Design and function of pneumatic components
•  Logic elements, logic diagram
•  Multi-way valves, pressure, shu t -off and flow control valves
•  Controls with starting and setup conditions (automatic/manual/jog mode)
•  Controls with boundary conditions 
•  Routing and time controls (process and time controlled sequencers)
•  Position-dependent controls
•  Troubleshooting and commissioning Specification 

 [1]   Comprehensive trainer for demonstration and exercises in pneumatics, electro -pneumatics and PLCs
 [2]   2 Perforated metal panels for quick component fixing
 [3]   Standard industrial pneumatic and electro -pneumatic components
 [4]   Various multi -way valves, pressure, shut -off and flow control valves 
 [5]   Electric limit switch, various proximity switches, solenoid valves, signal board
 [6]   PLC with programming software 
 [7]   Integrated power supply unit to supply the electro -pneumatics and the PLC
 [8]   2x maintenance units + distributor block for simultaneous use of both panels
 [9]   Hoses, cables and tools to construct the experiments 
[10]  Miniature compressor for compressed air supply 
   Technical Data to assembly panels, LxH: 1100x700mm each Compressor

• Tank: 24L 
• Intake capacity: 50L/min
• Power output: 32L/min at 8bar
• Max. pressure: 8bar
• Motor: 0,34kW PLC with display
• Inputs: 8 
• Outputs: 4
• EEPROM
• Programming software Size of components:

 Nominal width 3 Pneumatic hose: 4/2mm Power supply unit: 24VDC, 4A 230V, 50Hz, 1 phase 230V, 60Hz, 1 phase 120V, 60Hz, 1 phase Dimensions and Weight LxWxH: 1530x750x1540mm Weight: approx. 160kg