Digital & Analog Bread Board Trainer

Order Code: 21225100.2

Category: General Lab Equipment I

Solderless Breadboard: Interconnected with tie 2820 points nickel plated contact, fitted with all dip sizes and all components with lead and solid wire AWG  22-30 (0.3-0.8mm). It can be changed and replaced for different purposes and can be...



SPECIFICATION

  • Solderless Breadboard:
  • Interconnected with tie 2820 points nickel plated contact, fitted with all dip sizes and all components with lead and solid wire AWG  22-30 (0.3-0.8mm). It can be changed and replaced for different purposes and can be connected with demonstration panel. Therefore, it is very convenient for both teachers and students
  • Dc Power Supply
  • A.Fixed Dc Output: 5v, 12v @ 500ma
  • B.Fixed Dc Output: -5V, 1 A – Not Specify
  • C.Variabledc :output dual 0~30v, 0~ -30v @ 500ma
  • D.Variable Dc Output: 0v To ?15V, 1 A - Not Specify
  • Potention Meters
  • A. Variable Resistor Vr1: 1kohm
  • B. Variable Resistor Vr2: 100kohm - 10Kohm
  • 8 Function Generator
  • Frequency Range: 1hz-10hz
  • 10hz-100hz
  • 100hz-1khz
  • 1khz-10khz
  • 10khz-100khz
  • Amplitude: Sine Wave Output:0-10 Vpp Variable -  0 ~ 6 vpp variable
  • Triangle Wave Output:0-10 Vpp Variable - 0 ~ 6 vpp variable
  • Square Wave Output:0-10 Vpp Variable - 0 ~ 6 vpp variable
  • Ttl Mode Output:4 Vpp - 5v@1hz~1mhz in 5 steps
  • Two Digits Of 7 Segment Led Display
  • Two Pulse Switch: 2pcs Pushbuttons - one pulse switch Contain Switches Debouncer For Eliminating 
  • Data Switches: Toggle Switches And Corresponding Output Point.When Switch Is Set At down position,the Output Islo Level; Contrarily, It Is To Be High Level While Setting At up position.
  • 8 Ohm/0.5w To Be Used For Load.
  • Four Channel Adaptor: Both Of The Two Banana Sockets' And  Bnc Jacks'  suitable for the trainer to be connected with peripherals
  • Six.Teen Bits Led Display:  Red Led's Separate Input Terminals. The Led Will Be Lighted Up When Input is at  turned off when it is at
     

Enquiry Form