Multivibrators with power supply and 1 meters

Products Categories

Multivibrators with power supply and 1 meters

Order Code: 36195

SPECIFICATION

Experimental Training Board has been designed specifically for the study of Multivibrator circuits. Apart from basic circuits some special techniques have also been included.
Practical experience on this board carries great educative value for Science and Engineering Students.

Object:
To study multivibrator circuits.
Experiments:
01. Design of multivibrators.
02. To study the waveforms of a free running multivibrator.
03. To design and make a bistable multivibrator and to study its D.C. conditions.
04. To design and make a monostable multivibrator and to adjust its delay time.
05. To design and make schmitt-trigger and study its hysteresis.
06. To control the frequency of a free running multivibrator with applied voltage.
07. To design and make a gated free running multivibrator.
08. To design and make an improved free running multivibrator.

Features:
The board consists of the following built-in parts :
1. ±9V D.C. at 100mA, IC regulated Power Supply.
2. 0-9V D.C. at 5mA, IC regulated Power Supply.
3. Digital Voltmeter DC 3½ Digit range of 0-20V.
4. Pulser for triggering the circuit.
5. Three NPN transistors.
6. Adequate no. of other Electronic Components.
7. Mains ON/OFF switch, Fuse and Jewel light.

The unit is operative on 230V ±10% at 50Hz A.C. Mains.
Adequate no. of patch cords stackable from rear both ends 4mm spring loaded plug length ½ metre.
Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections & observation of waveforms.
Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

Other Apparatus Required:
Cathode Ray Oscilloscope 20MHz